close
close

How To Light A Pilot Light On A Trane Furnace

th 761

How To Light A Pilot Light On A Trane Furnace. Not all furnaces have this red light. Rotate the gas control dial to the 'off' position and wait five minutes to allow any residual gas to dissipate.

Gas Furnace Lights Stays Lit 12 Minutes, Clicks, Then
Gas Furnace Lights Stays Lit 12 Minutes, Clicks, Then from www.diyforums.net

How to light a pilot light on a trane furnace set the central furnace thermostat to 'off' or the lowest temperature option. When lit, this red light, also called a lockout light, indicates that a safety mechanism on your furnace has caused a shutdown because it has detected a problem or recognized a fault. Rotate the gas control dial to the 'off' position and wait five minutes to allow any residual gas to dissipate.

A Number Of Things Can Make An Old Furnace Pilot Light Go Out, Including A Strong Draft, A Faulty Thermocouple Or A Loss Of Gas.

How to light a pilot light on a trane furnace set the central furnace thermostat to 'off' or the lowest temperature option. How to light a pilot light on a trane furnace set the central furnace thermostat to 'off' or the lowest temperature option. Not all furnaces have this red light.

Light The Pilot On A Trane Furnace By Holding A Flame To The Orifice While Holding In The Gas Control.

How to light a pilot light on a trane furnace set the central furnace thermostat to 'off' or the lowest temperature option. Furnace manufacturers have all but phased out standing pilot ignition systems for gas furnaces, so if you have to light the pilot light on your trane furnace, it's because the furnace is more than 20 years old. An older gas furnace has a standing pilot that stays on all the time — or at least, it's supposed to.

Turn The Electrical Power To The.

How to light a pilot light on a trane furnace set the central furnace thermostat to 'off' or the lowest temperature option. A modern gas furnace usually has an electronic spark generator to ignite the gas when the thermostat calls for heat. If the flame won't keep burning, consider a service call.

Light The Pilot On A Trane Furnace By Holding A Flame To The Orifice While Holding In The Gas Control.locate The Pilot Light As Well As Its Switch.make Sure.

Rotate the gas control dial to the 'off' position and wait five minutes to allow any residual gas to dissipate. Light a match and hold it near the pilot opening while you press the reset button on the pilot control panel. Access the furnace controls by opening the metal door at the bottom front side of the trane furnace.

When Lit, This Red Light, Also Called A Lockout Light, Indicates That A Safety Mechanism On Your Furnace Has Caused A Shutdown Because It Has Detected A Problem Or Recognized A Fault.

Gas valve clicks and lets gas go through 5 suggestions to prevent trane furnace red light flashing 2 times. Trane xe70 propane furnace will not ignite pilot after shutting off propane at tank and then back on. Rotate the gas control dial to the 'off' position and wait five minutes to allow any residual gas to dissipate.

Leave a Reply

Your email address will not be published.